Lucent Technologies P550 - Manual (Page 186)

Configuring the OSPF Routing Protocol (Layer 3)
9 -4 Cajun P550/P220 Switch Operation Guide
2. Select the OSPF area to be removed.
3. Click DELETE. The OSPF area is removed.
Modifying OSPF Areas
To modify an OSPF area:
1. In the OSFP Configuration section of the Web Agent window, click Areas. The
OSPF Areas dialog box opens.
2. Select the OSPF area to be modified.
3. Use Table 9-2 to modify your configuration.
4. Click APPLY to save your changes, or CANCEL to restore previous settings.
Modifying OSPF Interfaces
To modify an OSPF interface:
1. In the OSPF Configuration section of the Web Agent window, click Interfaces.
The OSPF Interfaces dialog box opens.
Note: If OSPF is not enabled for your existing IP interfaces (VLANs) you must first
enable OSPF before you can modify OSPF interfaces. Refer to “Configuring
IP Interfaces” in Chapter 7 for more information on how to enable OSPF on
IP interfaces.
2. Use Table 9-3 to determine how to modify your OSPF interfaces:
Table 9-3. OSPF Interface Parameters
Parameter Definition
Select Select the OSPF interface to be modified.
Interface Displays IP interface (VLAN) that has OSPF enabled.
Note: This is a read-only field.
IP Address Displays IP address associated with the OSPF interface.
Note: This is a read-only field.
Area Enter the area ID configured for this interface.
DR Priority Enter the decimal value for this interface for DR priority
functionality.
Transit Delay Enter the estimated number of seconds it takes to transmit a link
state update packet over this interface.