Lucent Technologies P550 - Manual (Page 169)

Configuring IP Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 7-43
Enabling VRRP
To enable a VRRP virtual router:
1. In the IP Configuration section of the Web Agent window, click Global
Configuration. The IP Global Configuration dialog box opens.
2. From the VRRP pull-down menu, select Enable.
3. Click APPLY to save your changes, or CANCEL to restore previous settings.
Enabling VRRP on an Interface
To enable an VRRP virtual router on an interface:
1. In the IP Configuration section of the Web Agent window, click Interfaces. The
IP Interfaces dialog box opens.
2. Select the interface to be enabled.
3. From the VRRP pull-down menu for your interface, select Enable.
4. Click APPLY to save your changes, or CANCEL to restore previous settings.
Note: You must enable VRRP globally from the IP Configuration/Global
Configuration dialog box.
Creating a VRRP Virtual Router
To create a VRRP router:
1. In the IP Configuration section of the Web Agent window, click VRRP
Configuration. The VRRP Configuration dialog box opens.
2. Click CREATE. The Add VRRP Virtual Router dialog box opens.
3. Use Table 7-31 to configure your VRRP parameters:
Table 7-31. VRRP Configuration Parameters
Parameter Defines...
Interface The name associated with the selected interface to
configure.
VR ID The reporting virtual router’s identification. The ID
range is 1-255 (decimal).
IP Address The virtual router’s IP address.