Lucent Technologies P550 - Manual (Page 61)

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
Cajun P550/P220 Switch Operation Guide 3 -15
Table 3-7 describes Switch Port configuration parameters:
Table 3-7. Switch Port Configuration Parameters
Parameter Definition
Port VLAN Specifies the VLAN assignment for this port.
Trunk Mode Select the trunk mode.Allows you to define
the port as a trunk and allows you to select
the appropriate VLAN trunking format if the
port is connected to another switch. Refer to
Table 3-8 for more information on trunk
mode options.
Frame Tags Select whether to ignore or use received
Frame VLAN tags. If you ignore VLAN tags
on incoming frames, the frames are bound to
the port’s default VLAN. The default value is
Use.
VLAN Binding Select the port’s outgoing VLAN binding
type. Refer to Table 3-9 for more information
on VLAN binding options.
Automatic VLAN
Creation Select to enable or disable the ability to
automatically create a VLAN each time the
port receives a frame from an unknown
VLAN. The default value is Disable.
VTP Snooping Select to enable or disable VTP Snooping on
this port. The default value is Disable.
Allow Learning Select to enable or disable the port’s learning
of new addresses. The default value is
Enable.
Hunt Group Select a hunt group for which this port will
be a member. The default value is None.
Spanning Tree Mode Select to enable or disable spanning tree
protocol on this port. The default value is
Enable.
Note: For the Cajun P220 switch, you
will be unable to modify this
feature on the CPU switch port.
Fast Start Select to enable or disable fast start on this
port. The default value is Disable.
Note: For the Cajun P220 switch, you
will be unable to modify this
feature on the CPU switch port.