Lucent Technologies P550 - Manual (Page 116)

Configuring IPX RIP Protocol (Layer 3)
5-4 Cajun P550/P220 Switch Operation Guide
Example: Suppress Advertising of Network 10
To configure your switch to suppress the advertising of network 10 on the IPX interface
named Backbone:
1. In the IPX RIP Configuration section of the Web Agent, click Filters.
2. Click Create to create a new filter. The Add IPX RIP Filter dialog box opens.
3. Configure the following parameters:
a. From the Interface pull-down menu, select the Backbone.
b. In the Precedence field, enter 0.
c. In the Start Network field, enter 10.
d. In the End Network field, enter 10.
e. From the Direction pull-down menu, select Outbound.
f. From the Filter/Suppress pull-down menu, select Enable.
g. In the Ticks and Hops fields, enter 0.
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
This filter ensures that all advertising of network 10 from the interface Backbone is
suppressed.
Example: Suppress Advertising of all Networks Except 10
To configure your switch to suppress the advertising of all networks except network 10
on the IPX interface named Backbone, you must create two filters.
To create these filters:
Filter 1
1. In the IPX RIP Configuration section of the Web Agent window, click Filters.
2. Click Create to create a new filter. The Add IPX RIP Filter dialog box opens.
3. Configure the following parameters:
a. From the Interface pull-down menu, select the Backbone.
b. In the Precedence field, enter 0.
c. In the Start Network field, enter 10.
d. In the End Network field, enter 10.
e. From the Direction pull-down menu, select Outbound.
f. From the Filter/Suppress pull-down menu, select Disable.