Lucent Technologies P550 - Manual (Page 146)

Configuring IP Routing (Layer 3)
7-20 Cajun P550/P220 Switch Operation Guide
2. Use Table 7-10 to complete your DVMRP configuration:
3. Click APPLY to save your changes, or CANCEL to restore previous settings.
Table 7-10. DVMRP Interface Parameters
Parameter Defines the...
Select DVMRP interface to be configured.
Interface Interface that is configured with the DVMRP multicast
protocol.
IP Address IP address of each interface. Not configurable.
IP Address Mask Subnet mask of each interface. Not configurable
Interface Type Interface type for each interface. You can configure the
interface type as:
• Broadcast - All traffic is forwarded through the
routers. This is not a tunnel and does not require
encapsulation.
• Non-Encapsulated Tunnel - All multicast data
traffic is IPIP encapsulated, but the protocol
messages are simply unicast.
• IPIP Tunnel - All multicast traffic (data and
protocol messages) on this interface is encapsulated
in IP unicast packets with the protocol set to IPIP
(IP in IP).
Tunnel Endpoint
Address Tunnel endpoint IP address of a router. Configure this
setting to represent the IP address of the end router to
which you want to send datagrams through a tunnel.
Typically, the origin and endpoint routers are separated
by a gateway(s) or a router(s) that do not support
DVMRP.
Interface Metric Cost metric for the interface.
Src Host Addr in Prune
Msg Transmission of prunes.
• Enable - Send prunes with the full source host
address.
• Disable - Send prunes with only the subnet portion
of the source address.
Interface Scope Minimum TTL (time-to-live) required for a packet to
leave this interface (None, 127, 255).