Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 106)

SENSOR 1 SENSOR 2 SOURCE
SYS
RS 232 USB CONFIG
O
N
ON
OFF
DC
IN
FRONT
BACK
LED
FIGURE F.18 – POLHEMUS (FRONT)
POLHEMUS MODULE REMOVAL AND REPLACEMENT
PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Install the new Polhemus Module using Hook
& Loop mounting pads.
2. Connect the five previously removed cables to
the Polhemus Module.
NOTE:
Make sure that the ON/OFF switch at the
rear of the Polhemus Module is in the “ON”
position. Also make sure that the five pins
on the dip switch are in the “OFF” position
(down).
3. Perform
Case Cover Replacement
Procedure
.
4. Perform the Monitor and Pedestal
Replacement Procedure
.
5. See Retest After Repair.
TROUBLESHOOTING AND REPAIR F-49 F-49
VRTEX TM 360
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC