Operation, Process selection screen, Stand set-up screen – Lincoln Electric VRTEXTM 360 SVM200-A User Manual
Page 28
OPERATION
B-10
B-10
VRTEX
TM
360
Process Selection Screen:
Overview
This screen allows the user to select the welding
processes. To change among VR GMAW, VR FCAW,
and VR SMAW, the user moves the process switch on
the front of the weld machine. See the joint configura-
tion chart for available processes. If a process is not
supported for the selected material/thickness, it is
greyed out on this screen and cannot be selected. To
choose among different sub-processes, use the joy-
stick and red select button or green continue button.
At the top of the screen, the user can see the coupon
position and thickness selected. As the user continues
to set up the simulation, additional information will be
added to the right of this readout, so that the user can
reference what has previously been selected.
Menu
Selecting Logout brings the user back to the login
screen, with the userʼs name removed.
Change Coupon Type
Selecting Change Coupon Type goes back to the
configuration selection screen.
Back
Selecting Back takes the user to the previous screen.
Stand Set-Up Screen:
Overview
The correct VR stand information must be put into
the software for the VRTEX
TM
to operate properly in
all virtual welding applications.
PROCESS SELECTION SCREEN
STAND SET-UP SCREEN
Coupon Insertion
Insert one of the VR coupons into the desired position
in the physical VR stand. Make sure the coupon is
seated into the track and then lock the coupon in place
by pushing in the knob at the end of the arm. To
release, pull the knob into the unlocked position and
remove the coupon. When the system is in use, the
coupon should always be locked in place to assure
system accuracy.
VR COUPON (UNLOCKED POSITION)