Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 148)

FIGURE F.42 – STRAIN RELIEF
VR SMAW (STICK) DEVICE
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Install the new VR SMAW Device by replacing
the two screws securing the sheet metal strain
relief to the front panel.
2. Connect plug J3 to the relay board.
3. Reconnect the 16 pin molex cable splice.
4. Turn on input power.
5. Perform
Case Cover Replacement
Procedure
.
6. Perform the Monitor and Pedestal
Replacement Procedure
.
7. See the Retest After Repair.
TROUBLESHOOTING AND REPAIR F-91 F-91
VRTEX TM 360
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC