Operation, Environment screen, Gas set-up screen – Lincoln Electric VRTEXTM 360 SVM200-A User Manual
Page 30
OPERATION
B-12
B-12
VRTEX
TM
360
Environment Screen:
Overview
The VRTEX
TM
360 comes pre-configured with a num-
ber of different virtual welding environments. To select
an environment, the user moves the joystick left or
right and then presses the red select button or green
continue button to choose the environment.
Menu
Selecting Logout takes the user back to the login
screen, with the userʼs name removed.
Back
Selecting Back takes the user to the previous screen.
Gas Set-Up Screen:
Overview
On this screen, the user selects the gas mixture and
gas flow rate. The user must enter the correct gas mix-
ture and flow rate according to the tolerance editor. If
the user does not enter acceptable values, they will be
notified on a later screen and may have to go back and
change their selection on this screen.
To select the gas mixture, use the joystick and the red
select button. The available gas mixtures are shown
on the gas set-up screen below.
To select the gas flow rate, use the joystick. Press the
red select button or green continue button to proceed.
ENVIRONMENT SCREEN
GAS SET-UP SCREEN
Menu
Selecting Logout takes the user back to the login
screen, with the userʼs name removed.
Back
Selecting Back takes the user to the previous screen.
STAND SET-UP SCREEN OVERLAY
Back
Selecting Back takes the user to the previous screen.
Indicate the coupon orientation used on the physical
stand in the coupon rotation area of the stand setup
screen. The red arrow indicates which side of the
coupon that the weld will be made. For pipe configu-
rations, the coupon rotation is replaced with arm angle.
The arm angle can be adjusted by removing the pin at
the end of the arm, rotating the arm to 45 or 90
degrees from its original location, and reinserting the
pin. This is only used to accommodate 2G, 5G & 6G
pipe welding.
The physical stand should match the stand image
when these selections are completed. To continue,
press the green continue button. The stand setup veri-
fication screen will be displayed. This screen serves as
a reminder to make sure VR stand components match
the screen. When verified, press the green continue
button again.
STAND SET-UP SCREEN (PIPE)