Operation – Lincoln Electric VRTEXTM 360 SVM200-A User Manual
Page 23
OPERATION
B-5
B-5
VRTEX
TM
360
Helmet
Users should first adjust the helmet so it fits comfort-
ably. Adjustments can be made by depressing and
turning the knob at the back of the helmet in until the
desired size is achieved. If necessary, the user may
also have to adjust the top crown adjustment to fit their
head size.
The helmet has an FMD (Face Mounted Display) on
the inside. These FMD lenses display the virtual weld
and environment to the user. The lenses can be shift-
ed left and right to fit comfortably by applying gentle
pressure. In addition, the lenses can be shifted for-
ward and back. The user should make sure the lenses
are parallel to their eyes. Keep the lenses clean at all
times. See Cleaning and Maintenance Section.
COUPON DRAWER
Coupon Drawer
The coupon drawer houses the physical coupons.
When not in use, the coupons should be stored there.
To open the drawer, press the top indent down, and
slide the drawer out. Each coupon fits in its own area
defined by the foam locator in the drawer.
Coupons
The coupons represent the various workpieces that the
user will virtually weld. During the virtual welding
process, they provide physical feedback to the student.
The coupons have been factory calibrated at Lincoln
Electric.
There are five VR Coupons:
1. Flat Plate
2. Tee Joint
3. 3/8” Groove Joint w/Backing Bar
4. 2” Diameter XXS Pipe
5. 6” Diameter Schedule 40 Pipe
HELMET FUNCTIONS
RATCHET KNOB
HEAD GEAR
FORE / AFT ADJUSTMENT
TILT ADJUSTMENT
CROWN
ADJUSTMENT
PIN HOLES FOR
ADJUSTMENT
HELMET LENSES
When not in use, the helmet should be hung from the
stand or placed in the right front drawer to avoid being
damaged.
LENSES
COUPONS
1
2
3
4
5
EAR
BUDS