Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 133)

INTERFACE MODULE
DIGITAL I/O
HORIZONTAL
MOUNTING
SHELF
INTERFACE MODULE (USB)
FIGURE F.33 – INTERFACE MODULE (USB) LOCATION
INTERFACE MODULE (USB)
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
Procedure
.
3. Perform the Case Cover Removal Procedure.
4. Locate the Interface Module (USB). See Figure
F.33.
5. Label and disconnect the USB cable. See
Figure F.34.
6. Unplug the 16-pin terminal strip from the
Interface Module (USB). See Figure F.34.
7. Carefully remove the Interface Module (USB)
from the top of the interface module digital I/O.
NOTE
: The Interface Module (USB) is secured to
the interface module digital I/O with Hook &
Loop mounting pads.
TROUBLESHOOTING AND REPAIR F-76 F-76
VRTEX TM 360
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC