Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 121)

12/15 VOLT SUPPLY
FIGURE F.25 – 12/15 VOLT SUPPLY MODULE LOCATION
12/15VDC SUPPLY MODULE REMOVAL AND REPLACEMENT PROCEDURE
(continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
Procedure
.
3. Perform the Case Cover Removal Procedure.
4. Locate the 12/15VDC Supply Module. See
Figure F.25.
Note:
There are two supply modules located next
to each other. Make certain that you are
removing the correct module.
5. Using a small flathead screwdriver, remove
leads 102B (white), 103C (pink/red) and the
green ground lead from the bottom of the
12/15VDC Supply Module. See Figure F.26.
6. Label and remove the positive and negative
leads (71, 71, 72, 72) from the top of the Supply
Module using the small flathead screwdriver.
See Figure F.26.
7. Push down on the release tab and lift up to
remove the 12/15VDC Supply Module from the
DIN rail.
TROUBLESHOOTING AND REPAIR F-64 F-64
VRTEX TM 360
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC