Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 140)

PLUG J37
(VIEWED FROM REAR)
FIGURE F.38 – DISPLAY LED BOARD PLUG LOCATION
DISPLAY BOARD
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Install the new Display Board onto the three
mounting stand-offs.
2. Replace plug J37 previously removed from the
Display Board.
3. Close the control panel.
4. Install the two 3/8” screws previously removed
from the top of the control panel.
5. Turn on input power.
6. See the Retest After Repair.
TROUBLESHOOTING AND REPAIR F-83 F-83
VRTEX TM 360
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC