See figure f.48, Troubleshooting and repair – Lincoln Electric VRTEXTM 360 SVM200-A User Manual
Page 160
Advertising
FIGURE F.48 – CASE BACK (REAR)
TABLE SWING ARM
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Replace the Table Swing Arm.
2. Carefully guide the Table Swing Arm cable
through the 1¾” access hole in the case back.
3. Insert the plastic grommet into the 1¾” access
hole.
4. Slide the new Table Swing Arm onto the top of
the top of the table mounting post.
5. Replace any previously removed cable ties.
6. Install the strain relief from the Table Swing Arm
cable previously removed from the rear of the
machine.
7. Connect the previously removed cable labeled
“SOURCE” to the polhemus module.
8. Perform
9. Perform the Monitor and Pedestal
10. See the Retest After Repair.
TROUBLESHOOTING AND REPAIR
F-103
F-103
VRTEX
TM
360
Advertising