Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 97)

FIGURE F.13 – VGA & POWER CORD LOCATION
MONITOR AND PEDESTAL REMOVAL AND REPLACEMENT PROCEDURE
(continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Disconnect the power supply cord and VGA
(blue) input cable from monitor. See Figure
F.13.
3. Using a phillips screwdriver, remove two bottom
monitor mounting screws. See Figure F.13.
4. Loosen the top two phillips screws and carefully
separate monitor from pedestal.
Note:
It is not necessary to completely remove the
top two phillips screws unless a new monitor
is required.
5. The monitor can now be removed.
Note:
It is not necessary to remove the pedestal if
just the monitor is to be replaced
6. Using a 7/16” wrench, remove the monitor
pedestal mounting screws. Note washer place-
ment upon removal. See Figure F.14.
7. Remove pedestal.
TROUBLESHOOTING AND REPAIR F-40 F-40
VRTEX TM 360
Power Cord VGA
Phillips Screws (4)
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC