Lincoln Electric VRTEXTM 360 SVM200-A - Manual (Page 15)

INSTALLATION A-6 A-6
VRTEX TM 360
10. Remove the four screws from the wooden rear
cross brace.
11. Remove the wooden cross brace while ensuring
the unit is steady and secure.
12. Carefully roll the machine off the rear of the skid.
Ramping may be required.
13. Uncrate and unpack the table and table base.
9. Using the 3/8” wrench, remove the two screws from
the rear base securing the unit to the wooden crate.
8. Remove the monitor from the back of the machine.
4. Carefully slide the crate assembly from the
VRTEX TM 360
.
5. Slide towards the rear of the machine. Be careful to
avoid damaging the welding device holders located
on each side of the machine.
6. Carefully remove the post (long rectangular
shaped cardboard box) from the crate.
7. Carefully cut and remove plastic wrapping.
3. Remove the six 3/8” bolts (three on each side) from
the bottom of the crate assembly.
FRONT
(upper)
BOLTS
FRONT
(lower)
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC