The students' reports are notaccessible, Troubleshooting and repair, Caution – Lincoln Electric VRTEXTM 360 SVM200-A User Manual
Page 70
FUNCTION PROBLEMS
Observe Safety Guidelines detailed in the beginning of this manual.
PROBLEMS
(SYMPTOMS)
POSSIBLE AREAS OF
MISADJUSTMENT(S)
RECOMMENDED
COURSE OF ACTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely,
contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed.
Call 1-888-935-3878.
CAUTION
The studentsʼ reports are not
accessible.
The studentsʼ reports can only
be saved via the USB port on
the front of the VRTEX
TM
360. If
a USB memory stick is not
plugged into the USB port or if
there is not available memory
on the USB stick the studentsʼ
reports will not be saved.
N/A
Previous weld pass data is not
accessible on the LASER screen.
“End Pass” must be activated
before starting a new pass. If a
new coupon is started the data
will only be available for the first
pass. Again “End Pass” must
be pressed before a new pass is
started
Use the joystick to go to pass
number and change which pass
data you are looking for.
Note that some configurations
only have one pass capabilities.
See the Lincoln default
tolerances.
N/A
Some or none of the welding
parameters,
defects,
or
discontinuities are graphing on
the LASER screen.
These items may be “toggled”
off. Use the joystick to highlight
the desired items and then
press the red select button to
toggle them on. Also, make
sure that you are on a currently
welded pass.
N/A
TROUBLESHOOTING AND REPAIR
F-13
F-13
VRTEX
TM
360
The user is not sure of which
tolerances they are using.
Whatever tolerance set that is
first displayed is the tolerance
set being used.
Go to the instructor mode to
change tolerances.
N/A