Toshiba LF516 - Manual (Page 102)

101
6 F 8 A 0 9 3 4
8.3 Parameter initial settings list
Unless otherwise specified, the default values for each parameter shown below are set when shipped from
the factory:
Parameter names Default value
Excitation frequency (*1)
Flow direction NORMAL
Display 1 gal/min
Display 2 COUNT B
Display digit setting
(for Display 1 and Display 2) 1/1000
Custom coefficient 1.0
Custom unit “ CUSTOM”(Head of character string is blank )
Range type Single
Range 1 300 gal/min
Ranges 2 to 4 0 gal/min
Hysteresis 3.0 %
Damping constant 5.0 s
Rate-of-change limit 0.0 %
Control limit time 0.0 s
Low cutoff 1.0 %
Display low cutoff LINEAR
Manual zero 0.0 %
4
−20mADC alarm output 4mA
Output low limit setting 4mA
Digital output 1 NO USE
Digital output 2 NO USE
DO1/DO2 active status NormOPEN
Digital input NO USE
DI detective level H LEVEL
Count rate 100 gal
Pulse width setting mode AUTO
Pulse width 5 ms
Preset count 00000000
Preset function HOLD
High alarm On/Off OFF
High alarm value 0.0 %
Low alarm On/Off OFF
Low alarm value 0.0 %
High-High alarm On/Off OFF
High-High alarm value 0.0 %
Low-Low alarm On/Off OFF
Low-Low alarm value 0.0 %
Empty pipe alarm NORMAL
Self-diagnosis On/Off ON
Converter alarm CONV ONLY
Fixed value output OFF
Fixed value current 4mA
Fixed value pulse 0 pps
Password 000
LCD density adjustment
3
Switch position setting BOTTOM
*1: See the setting values for each meter size in the table below.