Toshiba LF516 - Manual (Page 62)

61
6 F 8 A 0 9 3 4
/s /min /h /d
For Display 2 unit setting, select DSPL2 from the setting menu.
● How to select the display digit setting
When you select flow velocity or flow rate (custom unit is included), the screen automatically
moves to the display digit setting screen.
Using the display digit setting screen, you can change the decimal places used for the
measured value in the measurement mode.
Switch operation Display example Description
Either one of the flow velocity or flow rate
(custom unit is included) is selected, the
screen automatically moves to the display
digit setting screen.
This screen shows the set measured value
and unit.
Pushing
or changes the
setting of display digit and the measured
value indication changes accordingly.
When the desired item is selected, push
to set the item temporarily.
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push
. If you need to redo the
setting, push .
Pushing
cancels the setting operation
and exits the setting screen.
Note: If the setting is cancelled without completing the display digit setting, the previously
used display digit setting will be used.
For display digit setting screen, the measured value is displayed in the screen based on the display
setting in the previous screen (display setting screen) and thus select the display digit setting while
observing the displayed measured value.
You can change the display digit with 1/10, 1/100, 1/1000 three phases for the setting range's maximum
effective digits. When setting range is more than 1000, a lower digit is not displayed from the decimal
point.