Toshiba LF516 - Manual (Page 141)

140
6 F 8 A 0 9 3 4
13.2 Troubleshooting
If a problem occurs while using the flowmeter, you may find the cause of the problem by a simple check.
Please follow the flowmeter before you contact a serviceperson.
13.2.1 Flow rate is not indicated.
Are power supplies correct
for each device? Use the correct power supply
for each device.
Are power and I/O cables
installed correctly?
Install the cables correctly.
Refer
to Chapter 5, “Wiring.”
Is the fuse not burnt?
Replace the fuse with a new
one.
Is the flow range correctly
set?
Set correctly. Refer to
Chapter 8, “Configuration
Parameter Setting.”
Is the flow direction
match with the arrow
mark on the detector?
Install the detector correctly.
Refer
to Chapter 4,
“Mounting Procedure.”
Contact your nearest Toshiba
representative.
NO
NO
YES
NO
NO
START
YES
YES
YES
NO
YES