Toshiba LF516 - Manual (Page 60)

59
6 F 8 A 0 9 3 4
Switch operation Display example Description
The currently set flow direction (NORMAL
in this example) appears.
Then push .
* Pushing returns you to the setting
menu.
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
You can continue to change the setting item.
Pushing changes the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
Perform this operation to change the setting
to SWITCH.
When the desired item is obtained, push
to set the item temporarily.
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push . If you need to redo the
setting, push .
Pushing cancel the setting operation
and exits the setting screen.
8.2.6 Display Setting
You can select one of the engineering units listed below as a flow measurement unit.
Flow velocity unit m/s, ft/s
Flow rate unit
(Note3)
m
3
/s, m
3
/min, m
3
/h, m
3
/d , L/s, L/min, L/h, L/d,
mL/s, mL/min, mL/h, mL/d, gal/s, gal/min, gal/h, gal/d,
bbl/s, bbl/min, bbl/h, bbl/d, pt/s, pt/min, pt/h, pt/d,
qt/s, qt/min, qt/h, qt/d
ft
3
/s, ft
3
/min, ft
3
/h, ft
3
/d, Mgl/s, Mgl/min, Mgl/h, Mgl/d
Volume unit m
3
, L , mL , gal , bbl , pt , qt, ft
3
, Mgl
Other units % , COUNT , RANGE , GRAPH , CUSTOM
Totalized flow direction
Forward direction (when F or B is selected)
Reverse direction (when R or B is selected)
Totalized difference flow Difference between totalized forward flow and totalized
reverse flow (when totalized flow direction D is selected)
Note 1: If COUNT, RANGE, GRAPH or CUSTOM is selected, the display is shown below: