Micromod Micro-PWC: 53PW6000 MicroPWC Operators Manual - Manual (Page 41)

Micro-PWC OPERATOR’S MANUAL
Micro-PWC Features 27
To create an Operator Message, select Menu > Configure > Message Configuration. The Message Config-
uration window (
Figure 3-3 ) will be displayed.
The window is used to configure the text, priority, and destination of the Operator Message.
3.3.2.1 Message Text
To configure the text of the message, click in the text entry box located at the top of the Message Configu-
ration window and enter a message of up to 80 ASCII characters.
3.3.2.2 Message Priority
Each message is associated with a priority. To set the priority, click in the Priority text entry box and enter
the number of the desired priority (range of 1 to 16).
3.3.2.3 Message Destination Area
Each message can be associated with a specific plant area. The Area assignment is used to route the
message to the devices (files, printers) which have been configured to receive Operator Messages associ-
ated with that area. The message will also be sent to all Micro-PWCs where users who have access to that
area are logged in. On the Micro-PWCs, the message will be displayed in the Message line (bottom line) of
the Mini-Alarm Window. To assign the Operator Message to an Area, click the Area button. The Area
Selection window (
Figure 3-4 ) will be displayed.
TC00032A
Figure 3-3. Message Configuration Window
TC00033A
Figure 3-4. Area Selection Window