Abbott Freestyle PRT03831-xxx - Manual (Page 100)

Status Information
The receiver can provide you with a number of different types of Status Information. Available
Status Information is listed in the following table. To access the Status information, press the
RIGHT option button twice to get to the Main menu and use the UP or DOWN arrow button to
highlight System. Select System by pressing the RIGHT option button. Highlight and select Status
from the System menu.
Removed Sensor Allows you to indicate you are removing a Sensor
so the Data Loss Alarm will not set off. Use this
only if you are removing a sensor.
Note: Once you select this option, the system will
terminate any active sensor.
System Status Shows information about the System, including
Sensor life remaining (in hours) and time since
valid data was transmitted (in hours).
Receiver Status Shows information about the receiver, including
serial number and software version (may be useful
when calling Customer Care), as well as battery life
remaining.
Transmitter Status Shows the transmitter’s serial number. You may need
to verify the serial number after linking to a new
transmitter. This unique value is used by the receiver
to accept data from only the transmitter the receiver
is linked to. It also shows battery life remaining.
After replacing the battery, once the system has
recognized the new battery, it will display battery life
as 75-100%. If there is no connection between the
transmitter and receiver, you will see 3 dashes, “- - -”,
instead of the battery life.
Status Information Description
Customer Care: 1-866-597-5520
90 Section 10
Respond to Alarms, Errors, and Problems
08:30A
No Yes
Did You Remove
The Sensor?
System Status 08:30A
Sensor Life Left 000:000
Time Since
Sensor Data - - -
Back Main
Receiver Status 08:30A
Serial #: BAAH190-80020
SW Version: 0.61
Battery Life: 75-100%
Back Main
Transmitter Status 08:30A
Transmitter ID:
AAAH298-80008
TX Battery: 75-100%
Back Main