Abbott Freestyle PRT03831-xxx - Manual (Page 147)

15
OVER
15 Reset User Settings
Purpose
To reset the user settings to the default values.
Start
Do this procedure anytime you feel a need to return your settings to the factory
defaults.
Materials
Your FreeStyle Navigator Receiver.
Helpful Information
• If you don’t press any button within 12 seconds, the receiver screen will go blank and the last
change will be lost if you haven’t pressed the Select button.
• Be careful to avoid making unintentional changes to the system settings and configuration.
• Resetting user settings resets the following items to their default. Note: The units of glucose
cannot be changed. [The default values are shown in brackets]:
Steps Do This
1.
Access the System menu
from the Main menu.
a. Press the UP or DOWN Arrow button to highlight
System.
b. Press the RIGHT Option button (Select) to go to the
System Menu screen.
• High Glucose Target.
[180 mg/dL (10 mmol/L)]
• Low Glucose Target.
[80 mg/dL (4.4 mmol/L)]
• Alarm Settings: [Med Beep]
– On/Off
– Low beep
– Medium beep
– High beep
– Short vibe
– Medium vibe
– Long vibe
– Alarm Thresholds
• Country Settings: [Local settings]
– Date format – Language
– Time format – Decimal format
• Displays for the items in the Add Event menu:
– Insulin type [Rapid] – Exercise intensity [Medium]
– Insulin dose [1 unit] – State of Health [Normal]
– Exercise type [Walking] – Generic Event [1]
– Exercise duration [30 min.]
• Strip Cal code. [18]
• Sensor Code. [109]
• Low Glucose Alarm.
[65 mg/dL (3.6 mmol/L)]
• High Glucose Alarm.
[300 mg/dL (16.7 mmol/L)]
Section 15 137
Reset User Settings
Main 08:30A
Glucose
Alarms
Reports
System
Add Event
Select