Abbott Freestyle PRT03831-xxx - Manual (Page 51)

OVER
Blue Release Tab
13.
Remove inserter
Steps Do This
11.
Remove the locking pin.
a. Grasp the top of the locking pin with your thumb and
index finger.
b. Twist the locking pin a 1/4
turn in either direction until
the locking pin clicks.
c. Pull the locking pin away to
remove it.
Note: The sensor support mount adhesive will help
keep the sensor support mount in place.
12.
Insert sensor.
a. Hold the sensor inserter as shown and press down on
both sides of the button at the same time.
Important: Do NOT press on the blue release tabs while
pressing the button on the top of the inserter.
Note: You will feel a slight pinch as the sensor is placed
just under your skin.
a. Hold the sensor inserter and firmly squeeze the two
blue release tabs at the inserter’s base, as you lift the
inserter away from the sensor support mount.
Note: Do NOT lift the inserter without squeezing
the blue release tabs as this may dislodge the sensor
support mount.
Caution: Do NOT press the button until you are ready
to insert the sensor. Doing so may cause unintended
results or injury.
Section 5 41
Insert or Remove Your Sensor