Abbott Freestyle PRT03831-xxx - Manual (Page 117)

OVER
You are not sure whether your receiver and transmitter
are connected.
You do not see the icon
on the screen.
Your system is connected.
You see the icon. There is no connection between the receiver
and transmitter. Reconnect the transmitter and
receiver, see Section 9.
You see the icon and
the reconnect procedure
was unsuccessful.
Check and make sure that the transmitter
battery is not old or exhausted.
If the battery is old or exhausted, then
a. Remove the sensor.
b. Change the battery.
c. Establish connection between transmitter
and receiver.
d. Insert a new sensor.
You continue to see the
icon even after replacing the
battery in the transmitter.
Wait for a couple of minutes after inserting the
new battery to allow the system to recognize
the new battery. If after two minutes, the
system still does not recognize the new battery,
there is probably something wrong with your
transmitter. Call Customer Care.
You see the “Link” message
on the screen.
Your system is not linked. Perform the steps
to link the system (Section 14). Make sure you
reconnect the system after linking (Section 9).
If Then
Section 10 107
Respond to Alarms, Errors, and Problems