Steps do this 1 – Abbott Freestyle PRT03831-xxx User Manual
Page 138
Steps
Do This
1.
Clean your transmitter.
a. Wash the transmitter with mild soap and water.
b. Rinse the transmitter thoroughly under running water.
c. Dry the transmitter thoroughly with a clean, soft, lint-
free towel.
d. Shake any water out of the transmitter’s contact points
and blot on a clean, dry, lint-free towel.
e. Make sure that the contact points are clean, dry, and
not excessively worn.
2.
Clean your receiver skin.
Before cleaning the receiver skin, remove it from the
receiver. Wash the receiver skin in mild soap and water.
3.
Clean your receiver.
Wipe the outside of your receiver with a clean, soft, lint-
free towel dampened with either a mild soapy solution or
70% isopropyl alcohol.
4.
Check your work.
Result: A clean transmitter, receiver and receiver skin.
You have done this procedure correctly when:
o
All visible dust, dirt, grime, and other foreign
substances have been removed.
o
The transmitter is thoroughly dry, including the
contact points.
Contact Points
END OF Section 13
Caution: Do NOT immerse the receiver in water or
in any other liquid. Avoid getting water or any other
liquid in the test strip port.
Customer Care: 1-866-597-5520
128
Section 13
Clean Your System