Abbott Freestyle PRT03831-xxx - Manual (Page 58)

Steps Do This
1.
Attach the transmitter to the
sensor support mount.
a. Position the transmitter over the sensor support mount
so that the battery side faces the mount.
b. Lower the transmitter onto the mount.
Note: It helps to position the transmitter’s connector
directly over the round part of the “keyhole” (Fig. 1)
as you lower the transmitter.
Result: The transmitter fits flush against the mount
and slides smoothly back and forth on the guide rails.
c. Hold the transmitter between your forefinger and thumb
and slide the transmitter until it clicks into place. Apply
firm pressure as you slide the transmitter into place.
(Fig. 2)
Fig. 1
Fig. 2
2.
Confirm the transmitter
is correctly attached to the
sensor support mount.
a. Look at the side of the transmitter where the bottom
sits on the guide rails.
b. Is there a space between the bottom edge of the
transmitter and the top edge of the guide rails?
• No The transmitter is correctly attached. Go to Step 3.
• Yes 1. Go to Section 5 to replace your sensor.
2. Repeat this procedure to attach your transmitter.
If Then
Note: It is normal to see a gap between
the transmitter and the support mount
towards the top.
Customer Care: 1-866-597-5520
48 Section 6
Attach Your Transmitter