Steps do this 7, If and then – Abbott Freestyle PRT03831-xxx User Manual
Page 72
Steps
Do This
7.
Interpret the blood glucose
results.
8.
Confirm you did NOT
use Control Solution.
Press the RIGHT Option button to indicate that you did
NOT use a Control Solution.
Press the RIGHT Option button to select ‘No’ and press
the RIGHT Option button again to view the continuous
glucose results. See Section 10 to respond to alarm
messages if there are any.
Note: If you do not select ‘No’ for the “Control Solution?”
question in this step within two minutes, the system
automatically considers it a blood test.
If
And
Then
• Lo appears in
the display. Lo
appears when
the measured
glucose result
is less than
20 mg/dL
(1.1 mmol/L).
You do NOT have low blood
glucose symptoms.
Repeat the test from Step 3
using:
• Your finger.
• A new test strip.
You have any of these symptoms:
• Weakness
• Headache
• Sweating
• Confusion
• Nervousness
Follow your healthcare
team’s recommendations
for treating hypoglycemia.
This is your second test.
• Hi appears in
the display. Hi
appears when
the measured
glucose result
is more than
500 mg/dL
(27.8 mmol/L).
You do NOT have high blood
glucose symptoms.
Repeat the test from Step 3
with a new test strip.
You have any of these symptoms:
• Fatigue • Excess urination
• Thirst • Blurry vision
Follow your healthcare
team’s recommendations
for treating hyperglycemia.
This is your second test.
• The receiver displays results from 20 to
500 mg/dL (1.1 mmol/L to 27.8 mmol/L).
Continue to Step 8.
Caution:
Low or high glucose measurements can
indicate a potentially serious medical condition.
Customer Care: 1-866-597-5520
62
Section 7
Calibrate Your System/Test Blood Glucose Manually
Glucose BG
08:30A
Yes No
Control Solution?
189
mg/dL