Allied Telesis AT-S63 - Manual (Page 119)

AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 119
Deleting a Static Port Trunk
To delete a static port trunk from the switch, perform the following
procedure:
Caution
Disconnect the cables from the port trunk on the switch before
performing the following procedure. Deleting a port trunk without first
disconnecting the cables can create loops in your network topology.
Data loops can result in broadcast storms and poor network
performance.
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Menu, type 4 to select Port Trunking and LACP.
The Port Trunking and LACP menu is shown in Figure 36 on page 112.
3. From the Port Trunking and LACP menu, type 1 to select Static Port
Trunking.
The Static Port Trunking menu is shown in Figure 37 on page 113.
4. Type D to select Delete Trunk.
The following prompt is displayed:
Enter Trunk ID: [1 to 6] ->
5. Enter the ID number of the trunk to be deleted.
The following prompt is displayed:
Are you sure you want to delete this trunk (Y/N) [Yes/No] ->
6. Type Y for yes to delete the port trunk or N for no to cancel this
procedure.
The port trunk is deleted from the switch.
7. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.