Allied Telesis AT-S63 - Manual (Page 336)

Chapter 21: SNMPv3
336 Section IV: SNMPv3
Configuring the SNMPv3 Access Table
This section contains a description of the SNMPv3 Access Table and how
to create, delete, and modify table entries. The SNMPv3 Access Table
allows you to configure a security group. Each user must belong to a
security group. After you have configured a security group, use the
SecurityToGroup Table to assign users to security groups. See “Creating
an SNMPv3 SecurityToGroup Table Entry” on page 352.
For each security group, you can assign the following attributes:
 a Security Model (SNMPv1, SNMPv2c, SNMPv3)
 Read, write, and notify views
 A security level
 A storage type
Before you begin this procedure, you will need to configure entries in the
View Table. These values are used to configure the Read, Write, and
Notify View parameters in this procedure. See “Configuring the SNMPv3
View Table” on page 327.
There are three functions you can perform with the SNMPv3 Access
Table.
 “Creating an SNMPv3 Access Table Entry,” next
 “Deleting an SNMPv3 Access Table Entry” on page 340
 “Modifying an SNMPv3 Access Table Entry” on page 342
Creating an
SNMPv3 Access
Table Entry
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 317. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 125 on page
318.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.