Allied Telesis AT-S63 - Manual (Page 463)

AT-S63 Management Software Menus User’s Guide
Section V: Spanning Tree Protocols 463
Displaying the MSTP Port State
To display the MSTP port state, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP Configuration menu is shown in Figure 161 on page 439.
3. From the MSTP Configuration menu, type P to select MSTP Port
Parameters.
The MSTP Port Parameters menu is shown in Figure 165 on page
456.
4. From the MSTP Port Parameters menu, type 4 to select Display MSTP
Port State.
The following prompt is displayed:
Enter Spanning Tree (CIST/MSTI) ID to display port state:
[0 to 15} ->
5. Enter an MSTI ID.