Allied Telesis AT-S63 User Manual
Page 453
AT-S63 Management Software Menus User’s Guide
Section V: Spanning Tree Protocols
453
6. Enter the VLAN ID of the virtual LAN that you want to remove from the
MSTI ID. You can enter more than one VLAN at a time (for example,
2,4,7) To view VIDs, refer to “Displaying VLANs” on page 481.
A removed VLAN is returned to CIST.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Associating
VLANs to an
MSTI ID and
Deleting All
Associated
VLANs
To associate VLANs to an MSTP ID while deleting all VLANs that are
already associated with it, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
3. From the MSTI Configuration menu, type V to select VLAN-MSTI
Association menu.
The VLAN-MSTI Association menu is shown in Figure 164 on page
451.
4. From the VLAN-MSTI Association menu, type 1 to select Add VLANs
to MSTI.
The following prompt is displayed:
Enter the MSTI ID <enter 0 for CIST> [0 to 15] ->
5. Enter the MSTI ID to which you want to associate a VLAN.
6. A prompt similar to the following is displayed:
Enter the list of VLANs:
7. Enter the VLAN ID of the virtual LAN that you want to associate with
the MSTI ID. You can enter more than one VLAN at a time (for
example, 2,4,7) (To view VIDs, refer to “Displaying VLANs” on
page 481.)
The VLANs already associated with the MSTI ID are removed when
the new VLANs are added. The removed VLANs are returned to CIST.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.