Allied Telesis AT-S63 - Manual (Page 470)

Chapter 24: Port-based and Tagged VLANs
470 Section VI: Virtual LANs
Creating a Port-based or Tagged VLAN
To create a port-based or tagged VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 170.
Figure 170. VLAN Configuration Menu
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
Note
The switch must be operating in the user-configured VLAN mode to
support port-based and tagged VLANs. To change a switch’s VLAN
mode, refer to “Selecting a VLAN Mode” on page 512.
Selection 6, Configure GARP-GVRP, is described in Chapter 25,
“GARP VLAN Registration Protocol” on page 491.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
VLAN Configuration
1 - Ingress Filtering Status ........ Disabled
2 - VLANs Mode ...................... User Configured VLANs
3 - Configure VLANs
4 - Show VLANs
5 - Show PVIDs
6 - Configure GARP-GVRP
R - Return to Previous Menu
Enter your selection?