Resetting mstp to the defaults – Allied Telesis AT-S63 User Manual
Page 466
Chapter 23: Multiple Spanning Tree Protocol
466
Section V: Spanning Tree Protocols
Resetting MSTP to the Defaults
To reset MSTP to the defaults, perform the following procedure:
Note
You must disable spanning tree to perform this procedure.
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select Configure
Active Protocol.
The MSTP Configuration menu is shown in Figure 161 on page 439.
3. From the MSTP Configuration menu, type D to select Reset MSTP to
Defaults.
The following message is displayed:
Do you want to reset MSTP configuration to default? [Yes/
No] ->
4. Enter Y for Yes or N for No and press Return.
The MSTP configuration is reset to the defaults.