Allied Telesis AT-S63 - Manual (Page 324)

Chapter 21: SNMPv3
324 Section IV: SNMPv3
The following prompt is displayed:
Please enter privacy password to regenerate privacy key.
9. Enter the Privacy Password for this User Name.
The following prompt is displayed:
Re-enter Privacy password:
10. Re-enter the password.
11. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Privacy Protocol and Password
To modify the Privacy Protocol and Password in an SNMPv3 User Table
entry, perform the following procedure.
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 317. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 125 on page
318.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 126 on page 318.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.
The Modify SNMPv3 Table menu is shown in Figure 127 on page 322.
4. Type 2 to select Privacy Protocol & Password.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter the User Name.
The following prompt is displayed:
Enter Privacy Protocol [D-DES, N-None]: