Allied Telesis AT-S63 - Manual (Page 570)

Chapter 31: 802.1x Port-based Network Access Control
570 Section VIII: Port Security
The Configure Authenticator Port Access Parameters menu is shown
in Figure 213.
Figure 213. Configure Authenticator Port Access Parameters Menu
6. Adjust the following parameters as necessary.
0 - Authentication Mode
This parameter can take the following values on an authenticator port:
 802.1x: Specifies 802.1x username and password authentication.
With this authentication method the supplicant must provide, either
manually or automatically, a username and password. This
authentication method requires 802.1x client software on the
supplicant nodes.
 MAC based: Specifies MAC address-based authentication. The
authenticator port extracts the source MAC address from the initial
frames received from a supplicant and automatically sends the
address as both the username and password of the supplicant to
the authentication server. Supplicant nodes must have 802.1x
client software for this authentication method.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
Configure Authenticator Port Access Parameters
Configuring Port 3
0 - Authentication Mode ...... 802.1x
1 - Supplicant Mode .......... Single
2 - Port Control ............. Auto
3 - Quiet Period ............. 60 Seconds
4 - TX Period ................ 30 Seconds
5 - Reauth Enabled ........... Enabled
6 - Reauth Period ............ 3600 Seconds
7 - Supplicant Timeout ....... 30 Seconds
8 - Server Timeout ........... 30 Seconds
9 - Max Requests ............. 2
A - VLAN Assignment .......... Enabled
B - Secure VLAN .............. On
C - Control Direction ........ Both
D - Piggyback Mode ........... Disabled
E - Guest VLAN ............... None
R - Return to Previous Menu
Enter your selection?