Enabling or disabling mld snooping – Allied Telesis AT-S63 User Manual
Page 305
AT-S63 Management Software Menus User’s Guide
Section III: Snooping Protocols
305
Enabling or Disabling MLD Snooping
To activate or deactivate MLD snooping on the switch, perform the
following procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
The Advanced Configuration menu is shown in Figure 117 on page
292.
2. From the Advanced Configuration menu, type 3 to select MLD
Snooping Configuration.
The MLD Snooping Configuration menu is shown in Figure 121 on
page 302.
3. From the MLD Snooping Configuration menu, type 1 to select MLD
Snooping Status.
The following prompt is displayed:
MLD Snooping Status (E-Enabled, D-Disabled) :
4. Type E to enable MLD or D to disable it. The default setting is disabled.
A change to the status of MLD snooping is immediately implemented
on the switch:
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.