Allied Telesis AT-S63 - Manual (Page 125)

AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 125
Creating an Aggregator
To create an aggregator, perform the following procedure:
Caution
Do not connect the cables to the ports of the aggregator on the
switch until after you have configured the aggregator with the
management software and enabled LACP. Connecting the cables
before configuring the software and activating the protocol will
create a loop in your network topology. Data loops can result in
broadcast storms and poor network performance.
Note
Before creating an aggregator, verify that the ports that will be
members of the aggregator are set to Auto-Negotiation or 1000
Mbps, full-duplex. Aggregate trunks do not support half-duplex
mode.
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 36 on page 112.
3. Type 2 to select LACP Configuration.
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 40
on page 122.
4. Type 3 to select Create Aggregator.