Allied Telesis AT-S63 - Manual (Page 455)

AT-S63 Management Software Menus User’s Guide
Section V: Spanning Tree Protocols 455
Configuring MSTP Port Settings
The MSTP port settings are divided into two groups. The parameters in the
first group are set just once on a port, regardless of the number of MSTIs
in which a port is a member. These settings are:
 External path cost
 Point-to-point designation
 Edge port designation
The procedure for setting these parameters is in “Configuring Generic
MSTP Port Settings,” next.
The second group of port parameters can be set independently for each
MSTI where a port is a member. These parameters are:
 Internal path cost
 Priority
To set these parameters, refer to “Configuring MSTI-specific Port
Parameters” on page 458.
Configuring
Generic MSTP
Port Settings
To configure the external path cost of a port or to designate whether the
port is an edge or point-to-point port, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP Configuration menu is shown in Figure 161 on page 439.
3. From the MSTP Configuration menu, type P to select MSTP Port
Parameters.