Modifying an aggregator – Allied Telesis AT-S63 User Manual
Page 128
Chapter 7: LACP Port Trunks
128
Section I: Basic Operations
Modifying an Aggregator
This procedure explains how to modify an aggregator. You can use this
procedure to change the load distribution method of an aggregator or to
add or remove ports. To modify an aggregator, you need to know its
name. To view the names of the existing aggregators, refer to “Displaying
LACP Port and Aggregator Status” on page 131.
Caution
If you will be adding or removing ports from the aggregator, you
should disconnect all network cables from the ports of the
aggregator on the switch before performing the procedure. Adding
or removing ports without first disconnecting the cables can result in
loops in your network topology, which can result in broadcast storms
and poor network performance.
To modify an aggregator, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP. The Port Trunking and LACP menu is shown in Figure 36 on
page 112.
3. Type 2 to select LACP Configuration. The LACP (IEEE 8023ad)
Configuration menu is shown in Figure 40 on page 122.
4. Type 4 to select Modify Aggregator.
The Modify LACP (IEEE 8023ad) Aggregator menu is shown in Figure
42.
Figure 42. Modify LACP (IEEE 8023ad) Aggregator Menu
Allied Telesis AT-9448T/SP - AT-S63
Marketing
User: Manager
11:20:02 02-Mar-2009
Modify LACP (IEEE 802.3ad) Aggregator
1 - Aggregator ..................
2 - Adminkey .................... 0x0000
3 - Distribution Mode ........... SRC/DST MAC
4 - Port Range ..................
M - Modify Aggregator
R - Return to Previous Menu
Enter your selection?