Allied Telesis AT-S63 - Manual (Page 61)

AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 61
Configuring Port Parameters
To configure the basic parameter settings for a port, such as speed and
duplex mode, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 14 on page 58.
2. From the Port Configuration menu, type 1 to select Port Configuration.
The following prompt is displayed:
Enter port-list ->
3. Enter the number of the port to be configured. You can configure more
than one port at a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or both (for
example 1,5,14-22).
The Port Configuration menu is shown in Figure 16.
Figure 16. Port Configuration (Port) Menu
Note
If you are configuring multiple ports and the ports have different
settings, the Port Configuration menu displays the settings of the
lowest numbered port. After you have configured the settings of the
port, all its settings are copied to the other selected ports.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
Port Configuration
Configuring Port 11
0 - Description ........................ Port_11
1 - Status ............................. Enabled
2 - HOL Blocking Prevention Threshold .. 682 cells
3 - Flow Control
4 - Filtering
5 - Rate Limiting
6 - Negotiation ........................ Auto
X - Reset Port
F - Force Renegotiation
D - Set Port Configuration to Defaults
R - Return to Previous Menu
Enter your selection?