Resetting stp to the default settings – Allied Telesis AT-S63 User Manual
Page 425
AT-S63 Management Software Menus User’s Guide
Section V: Spanning Tree Protocols
425
The Display STP Port Configuration menu displays a table that
contains the following columns of information:
Port
The port number.
State
Current state of a port. The possible states are Listening, Learning,
Forwarding, or Blocking when spanning tree is enabled on the switch.
When spanning tree is not enabled on the switch or if a port is not
being used, its state will be disabled.
Cost
Port cost of the port.
Priority
The port’s priority value. The number is used as a tie breaker when two
or more ports have equal costs to the root bridge.
Resetting STP to
the Default
Settings
To reset STP to the default settings, perform the following procedure:
Note
You must disable spanning tree to perform this procedure.
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The STP menu is shown in Figure 152 on page 419.
3. From the STP menu, type D to select Reset STP to Defaults.
The following prompt is displayed:
Do you want to reset STP configuration to default [Yes/
No] ->
4. Enter Y for Yes or N for No and press Return.
The STP configuration is reset to the defaults.