Allied Telesis AT-S63 - Manual (Page 268)

Chapter 15: Quality of Service
268 Section II: Advanced Operations
The Create Policy menu is shown in Figure 102.
Figure 102. Create Policy Menu
5. Configure the following parameters as needed:
1 - Policy ID
Specifies an ID number for the policy. Each policy on the switch must
be assigned a unique number. The range is 0 to 255. The default is 0.
This parameter is required.
2 - Description
Specifies a description for the policy. The description can be from 1 to
15 alphanumeric characters. Spaces are allowed. This parameter is
optional, but recommended. Names can help you identify the policies
on the switch.
3- Remark DSCP
Specifies whether the ingress DSCP value is overwritten. If All is
specified, all packets are remarked. If None is specified, the function is
disabled. The default is None.
4 - DSCP value
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
A new DSCP value can be set at all three levels: flow group, traffic
class, and policy. A DSCP value specified in a flow group overrides a
DSCP value specified at the traffic class or policy level. A DSCP value
specified at the policy level is used only if no value has been specified
at the flow group and traffic class levels.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
Create Policy
1 - Policy ID ................ 0
2 - Description ..............
3 - Remark DSCP .............. None
4 - DSCP value ...............
5 - ToS ......................
6 - Move ToS to Priority ..... No
7 - Move Priority to ToS ..... No
8 - Send to Mirror Port ...... No
9 - Traffic Class List .......
A - Redirect Port ............
B - Ingress Port List ........
D - Egress Port ..............
C - Create Policy
R - Return to Previous Menu
Enter your selection?