Allied Telesis AT-S63 - Manual (Page 376)

Chapter 21: SNMPv3
376 Section IV: SNMPv3
Inform messages only. The range is from 0 to 2,147,483,647
milliseconds. The default value is 1500 milliseconds.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Address Retries
The Target Address Retries parameter only applies when the message
type is an Inform message. To modify the Target Address Retries
parameter in an SNMPv3 Target Address Table entry, perform the
following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 317. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 125 on page
318.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is shown in
Figure 136 on page 369.
3. From the Configure SNMPv3 Target Address Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is shown in Figure
137 on page 373.
4. To modify the Target Address Retries, type 4 to select Set Target
Address Retries.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3
6. Enter the number of times the switch will retry, or resend, the Inform
message.