Allied Telesis AT-S63 - Manual (Page 92)

Chapter 4: SNMPv1 and SNMPv2c
92 Section I: Basic Operations
Creating an SNMP Community String
To create a new SNMP community string, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 2 on page 31.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 27 on page 90.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 & SNMPv2c Community.
The Configure SNMPv1 & SNMPv2c Community menu is shown in
Figure 28.
Figure 28. Configure SNMPv1 & SNMPv2c Community Menu
The table in the menu lists the current community strings on the switch
and their attributes. The columns in the table are defined here:
Community Name
The name of a community string.
Access Mode
The access mode of a community string. A string with a Read Only
access mode permits the viewing of the MIB objects on the switch. A
string with a Read/Write access mode permits both viewing and
changing the SNMP MIB objects.
Allied Telesis AT-9424Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
Configure SNMPv1 & SNMPv2c Community
Community Name AccessMode Status OpenAcc Manager IP Addr Trap Receiver IP
---------------------------------------------------------------------------
private
Read|Write Enabled Yes
public Read Enabled Yes
1 - Create SNMP Community
2 - Delete SNMP Community
3 - Modify SNMP Community
U - Update Display
R - Return to Previous Menu
Enter your selection?