Allied Telesis AT-S63 - Manual (Page 404)

Chapter 21: SNMPv3
404 Section IV: SNMPv3
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
 “Displaying the Display SNMPv3 User Table Menu,” next
 “Displaying the Display SNMPv3 View Table Menu” on page 406
 “Displaying the Display SNMPv3 Access Table Menu” on page 407
 “Displaying the Display SNMPv3 SecurityToGroup Table Menu” on
page 407
 “Displaying the Display SNMPv3 Notify Table Menu” on page 408
 “Displaying the Display SNMPv3 Target Address Table Menu” on
page 409
 “Displaying the Display SNMPv3 Target Parameters Table Menu” on
page 409
 “Displaying the Display SNMPv3 Community Table Menu” on
page 410
Displaying the
Display SNMPv3
User Table Menu
This section describes how to display the Display SNMPv3 User Table
menu. For information about the SNMPv3 User Table, see “Creating an
SNMPv3 User Table Entry” on page 317.
To display the Display SNMPv3 User Table menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 41.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 27 on page 90.
3. From the SNMP Configuration menu, type 6 to select Display SNMPv3
Table.