Allied Telesis AT-S63 - Manual (Page 357)

AT-S63 Management Software Menus User’s Guide
Section IV: SNMPv3 357
The Modify SecurityToGroup Table is displayed as shown Figure 132.
Figure 133. Modify SNMPv3 SecurityToGroup Table Menu
4. To modify the Group Name, type 1 to select Set Group Name.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter a User Name.
The User Name must be previously configured in the Configure
SNMPv3 User Table menu. See “Creating an SNMPv3 User Table
Entry” on page 317.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
6. Enter the Security Model configured for this User Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value if this User Name is configured with the SNMPv1
protocol.
2-v2c
Select this value to associate the User Name with the SNMPv2c
protocol.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Modify SNMPv3 SecurityToGroup Table
Security Model................. v3
Security Name ................. cleo72
Group Name .................... engineering
Storage Type .................. Volatile
Row Status .................... Active
1 - Set Group Name
2 - Set Storage Type
N - Next Page
U - Update Display
R - Return to Previous Menu
Enter your selection?