Allied Telesis AT-S63 - Manual (Page 547)

AT-S63 Management Software Menus User’s Guide
Section VII: Internet Protocol Routing 547
Modifying a Routing Interface
This procedure modifies the IP address and subnet mask of a routing
interface. Note the following before performing this procedure:
 Modifying the IP address of a routing interface deletes all static routes
assigned to the interface.
 Modifying the IP address of a routing interface that has RIP removes
the routing protocol from the interface and deletes all RIP routes
learned on the interface from the routing table.
 You cannot modify the RIP metric of a routing interface from the menus
interface. That task must be performed from the command line
interface using the SET IP INTERFACE command.
 You cannot change the name of a routing interface. The only way to
change the VID or interface number of an interface is to delete the
interface and recreate it.
To modify a routing interface, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 2 to select System
Configuration.
3. From the System Configuration menu, type I to select Configure
Interface.
The Configure Interface menu is shown in Figure 203 on page 544.
4. From the Configure Interface menu, type M to select Modify Interface.
The following prompt is displayed:
Enter Interface Name:
5. Enter the name of the interface (e.g., vlan2-1) to be modified.