Modifying a community string, Figure 29: modify snmp community menu – Allied Telesis AT-S63 User Manual
Page 95
AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations
95
Modifying a Community String
To modify a community string, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 2 on page 31.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 27 on page 90.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 &SNMPv2c Community.
The Configure SNMPv1 &SNMPv2c Community menu in shown in
Figure 28 on page 92.
4. From the Configure SNMPv1 &SNMPv2c Community menu, type 3 to
select Modify SNMP Community.
The Modify SNMP Community menu is shown in Figure 29.
Figure 29. Modify SNMP Community Menu
This menu lists the current community strings on the switch and their
attributes. For attribute definitions, refer to “Creating an SNMP
Community String” on page 92.
Allied Telesis AT-9424Ts - AT-S63
Marketing
User: Manager
11:20:02 02-Mar-2009
Modify SNMPv1 & SNMPv2c Community
Community Name
AccessMode
Status
OpenAcc
Manager IP Addr Trap Rec IP
---------------------------------------------------------------------------
Private
Read|Write
Enabled
Yes
Public
Read
Enabled
Yes
Private
Read|Write
Enabled
Yes
Public
Read
Enabled
Yes
1 - Add Attributes to Community
2 - Delete Attributes from Community
3 - Set Community Access Mode
4 - Set Community Status
5 - Set Community Open Access
U - Update Display
R - Return to Previous Menu
Enter your selection?